• The Leslie 3500 / 3500W / 991 cabinets are single channel cabinets having two rotors and three Rotor Modes. These cabinets contain a 300W High-Power amplifier (Bass 220W, Horn 80W). A massive 15˝ Woofer reproduces the deep bass sounds and a new custom Horn Driver containing a Neodymium magnet reproduces the higher frequencies. These drivers, combined with the 300W High-Power amplifier, produce a deep, powerful and dynamic sound.
• These cabinets are equipped with a transistorized “Push-Pull” amp that can create the classic “Overdrive” sound at any volume level without overloading the power amplifier or speakers.
• A 3-band equalizer and HORN LEVEL control are included that allow you to fine-tune the sound quality to your preference.
• A variable-frequency BASS OUT jack is included that can be used as a Sub-Woofer or full-range reinforced output.
• These cabinets feature two input connectors - an 11-pin plug for connecting Hammond Organs such as XK-3, XK-3c, XK-5, etc. and a ROTARY INPUT jack for connecting instruments with standard 1/4˝ LINE OUT audio connections.
• The brushless DC Servo motors are not affected by power frequency variations or voltage changes, making them more stable under all performing conditions. These motors give you the ability to adjust the Slow and Fast speeds and Rise and Fall Times of the rotors.
• The 1/4˝ Foot Switch jack allows you to control the Leslie rotors using either a “normally open” (e.g. Hammond FS-9H) or a “latching” (e.g. Hammond FS-10TL) switch to change Rotor Modes.