SK PRO, SKX PRO, SKX, XK-5/-4/-3/-3C, A-162, A-405, XB-3/-3M etc.
■ Steps
1 Connect the organ to the cabinet as shown on the left.
• Cable used:
11-pin Leslie Cable LC11-7M (optional)
Note
• You can also connect the organ to two cabinets using the 11-pin Leslie “Y” Cable LC11Y-7M (optional).
• When using this connection, do not connect any cables or devices to the FOOT SW jack, ROTARY INPUT jack. This is to insure the Rotor Modes will switch correctly.
2 Turn the [11-PIN POWER REMOTE] switch to “OFF.”
3 If the organ has a provision for setting the number of channels of an external Leslie, set the [EXT.LESLIE CH] of the connected organ at 1.
Note
• Please refer to the Owner’s Manual of the organ for instructions on how to set the number of channels.
Tips
LESLIE CABLE
• Because a Leslie cabinet can receive both an audio signal and control voltages for operating the rotors, a special cable (Leslie LC11-7M) is used for connection between an organ and a Leslie Speaker having both audio and control signals.
• Both the Leslie connections are “keyed;” that is, each connection contains a notch which insures that the pins properly match up.