CONNECTING AN INSTRUMENT WITH A 1/4˝ AUDIO INTERFACE

■ Steps

1     Connect the cabinet and the instrument as shown above.

• Cable used:

1/4˝ mono phone cable (optional)

2     Turn the [11-PIN POWER REMOTE] switch to “OFF.”

3     Connect a Foot Switch (FS-9H or FS-10TL) to the [FOOT SW] jack.

Note

• A Foot Switch must be connected to the cabinet in order to switch Rotor Modes.

4     Select the Foot Switch Type using the [FOOT SW TYPE] selector.

• NON-LATCHING

Use Hammond FS-9H or similar “non-latching/normally open” switch. The rotors will switch between SLOW and FAST each time the Foot Switch is pressed. If the Foot Switch is pressed and held for 1.5 seconds or longer, the Rotors will STOP.

• FS-10TL

Use Leslie FS-10TL.


Note

• If your instrument has a built-in digital Leslie or “Rotary Cabinet” simulator, turn it “OFF” when using this connection.