Drum intro

You can perform a song with drum intro here. We will introduce two typical methods.

■ Fade-in (chord and bass)

1     Set the controls as shown.

Knobs and buttons

Setting

[Master Volume]

Center

[STRUMPLATE]

[Sustain]

Maximum

[Main Volume]

3 o'clock

[Sub Volume]

3 o'clock

[RHYTHM]

[Tempo]

Center

[Volume]

Center

[CHORD]

[Volume]

Minimum

[REAL TIME CONTROL]

[Chord Manual/Auto]

Auto

[Chord Hold]

Enabled (LED turned on)

[Rhythm Start/Sync Start]

Sync Start

2     Use the [VOICE] buttons to select a voice (⇒).

3     Use the [PATTERN] buttons to select a rhythm (⇒).

4     Press a chord button to select the chord used for the introduction.

Drum intro starts.

5     Rotate the [CHORD Volume] knob clockwise gradually.

The chord and bass sounds are gradually added.

■ Adding chord and bass together

1     Set the controls as shown.

Knobs and buttons

Setting

[Master Volume]

Center

[STRUMPLATE]

[Sustain]

Maximum

[Main Volume]

3 o'clock

[Sub Volume]

3 o'clock

[RHYTHM]

[Tempo]

Center

[Volume]

Center

[CHORD]

[Volume]

Center

[REAL TIME CONTROL]

[Chord Manual/Auto]

Auto

[Chord Hold]

Enabled (LED turned on)

[Rhythm Start/Sync Start]

Sync Start

2     Use the [VOICE] buttons to select a voice (⇒).

3     Use the [PATTERN] buttons to select a rhythm (⇒).

4     Press the [Rhythm Start/Sync Start] button to select “Start”.

Drum intro starts.

5     Press any of the chord buttons.

The chord and bass sounds are added at the same time.

Note

• To stop playing sounds, press the [Rhythm Start/Sync Start] button to select “Sync Start”, then tap the Instant OFF plate. The Instant OFF plate does not work when “Start” is selected.