Using the controllers

■ Pitch bend

Use these buttons to bend the pitch up or down.

NOTE:

• This function is available for Ens or Syn Instrument Types.

1     To raise the pitch, Press and Hold the [PITCH BEND UP] button.

To lower the pitch, Press and Hold the [PITCH BEND DOWN] button.

Tips

• Pressing and Holding the [PITCH BEND UP/DOWN] buttons will raise or lower the pitch by two (2) half steps or one whole step.

• Pressing and Holding the [PITCH BEND OCTAVE] button while pressing the [PITCH BEND UP/DOWN] buttons will raise and lower pitch one octave (12 half-steps).

2     To return to normal pitch while Pressing and Holding a [PITCH BEND] button, press the other [PITCH BEND] button.

For example, if you press the [PITCH BEND DOWN] button while Pressing and Holding the [PITCH BEND UP] button, the pitch will stop rising and the instrument will return to normal pitch.

3     To return to the original pitch, release the [PITCH BEND] button.

■ Expression pedal

Use an Expression Pedal to control the volume of the instrument.

Press forward with the front of your foot to increase the volume and back with the heel of your foot to decrease the volume.

The Expression Pedal will express the volume up to the limit set by the MASTER VOLUME knob.

Tips

• For information on compatible models, refer to “Connecting controllers”.

• The volume can be controlled when Expression is set at minimum (⇒).

■ Foot Switch

Use a connected Foot Switch to switch the Leslie rotor speed.

The Foot Switch will alternate between FAST and SLOW or STOP Modes each time it is pressed.

NOTE:

• This function is available for B-3, Vx, Farf or Ace Instrument Types.

Tips

• You can also enable/disable the FAST Mode of the Leslie effect using the [LESLIE FAST] button on the top panel (⇒).

• For information on compatible models, refer to “Connecting controllers”.

• Other functions can be assigned (⇒).